Posted by Farmerhr on February 10, 2013 at 19:37:07 from (22.214.171.124):
Does anyone know how IHC put the king pin into the wheel spindle ? When I look at the joint, I can see where the wheel spindle has be machined for the king pin and there is a center in the end of the king pin. There are no welds that I can see. I realize that the assembly was not made to be serviced. However; my wheel spindle is fine but the king pin has been welded on, ground, and mutilated and I would like to try and replace it. There are replacement assemblies available but I would like to explore rebuilding what I have. Thank You for any help you may be able to offer.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.