Farmall & IHC Tractors Discussion Board |
Re: How big is a IH 37 wheel disc?
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Plow Man on March 11, 2000 at 09:42:58 from (206.154.186.236):
In Reply to: How big is a IH 37 wheel disc? posted by Brian Schmidt on March 09, 2000 at 19:51:12:
I have a No.37 disk harrow and the manual and in the manual the widths in the front ranged from 8'6" to 14'. The rear gangs ranged from 8'6" to 14' also, and plus they all came in different spacings, such as 7" to 9". We have two tractors that can pull this disc, one is a 1949 Farmall "H". When I use this tractor, I put a "breather" on the two way clinder, and I also set the gauging strap two one of the higher holes. It only goes in the ground about 5" deep, and my H has no problem pulling it. The other tractor I use is a International 886. I can set the gauging strap lower, and I don't need the "breather". In your case, I don't think a C would pull the smallest model. If you our intrested, I could also make some copies of the manual and send them to you , if you supply a mailing address.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|