Farmall & IHC Tractors Discussion Board |
Re: FARMALL H 1951 REAR RIMS
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Janicholson on January 26, 2007 at 16:24:09 from (66.173.50.115):
In Reply to: FARMALL H 1951 REAR RIMS posted by city farmer on January 26, 2007 at 11:22:34:
They have tubes in them now. Clean the rust, chemical derust paste, wire brush, and effort. If they are thinned to the point of small pin holes, or thin sections, they are better off recycled for scrap. When clean, I would use a two part epoxy paint and apply it several inches beyond the rust. They look ok painted hammer tone silver, or galvanized "color" paint. If there are rough spots, sand them befor painting. Thin rims will (have) blown the sidewall out making a terrible noise, possible bodily injury, and property damage. Been there seen the results. Rims are available rather frequently. Check Salvage yards, farm tire stores, and put a add on this site. 38" Rims from early John Deere are identical (color may vary from the IH silver) JimN
Replies:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|