Farmall & IHC Tractors Discussion Board |
Re: Need replacement engine head for model 282 Int
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by the tractor vet on December 31, 2006 at 15:52:37 from (75.19.126.253):
In Reply to: Need replacement engine head for model 282 Interna posted by Laurie Suttmeier on December 31, 2006 at 14:45:10:
You can have that head FIXED look around your area for someone that does a prosess called cold weldingthey can fix that head and it will last . When putting it back together install a new thermostat and when using the tractor allow atleast a 10 min. warm up and if the tractor is up to operating temp . allow a cooldown till the gauge is back in the cold range also install a new temp gauge and pay attenshion to it . If you are in the Ind. Oh. Ky. area then Dan Roberts can more then likely help out on a replacement head and his Ph.# is 1 800 367 8751 vary good people to deal with as i have knowen him for 25 years.
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|