Farmall & IHC Tractors Discussion Board |
Front End Swap???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by steve in sc on September 27, 2006 at 16:48:35 from (216.218.125.155):
I've been poking around the internet to find out if a power steering setup from a 2444 will swap out with a non power set up on a 424. From what I can tell, it looks very similar but they're across the county from each other so it's tough to do a side by side comparison. The 424 is SN-01776 and the 2444 is SN-06038D. I don't know if that helps or not. It seems that the steering column and valve under the gas tank will have to move over to the 424... Other than that, it looks like it will all just bolt up under the nose of the 424 but I'm not sure. I'd rather get some expert opinions before spending the money and having parts pulled and sent to me to find out they won't fit. Thanks in advance for your time, steve in sc
Replies:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|