Farmall & IHC Tractors Discussion Board |
Re: Hey Magman ????
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by magman on July 29, 2006 at 05:57:01 from (67.142.130.19):
In Reply to: Re: Hey Magman ???? posted by CLIFF S on July 28, 2006 at 07:13:31:
Sorry Clif I have not got back to you. Its hard to say sometimes I chase shorts for hours. Make sure the point spring is away from the metal on the points. Make sure the wire that hooks to the point hold down is not near a ground. Start taking things off starting with the fron cover and put your hand over the nub on the coil and turn the mag back wards and start feeling for the power when you feell a small jolt you know that you found what ever you just unhooked was the short. I had a bad set of points yesterday I unhooked them and I got power you see. JON
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|