Farmall & IHC Tractors Discussion Board |
Re: Need a expert on 990 haybine
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy as in Randy-IA on July 02, 2006 at 20:50:42 from (207.177.83.79):
In Reply to: Need a expert on 990 haybine posted by Willy P on July 02, 2006 at 19:58:33:
Hi , Not an expert but I put new seals and bearings in my gearbox a while back and my retaining collars that the seals rode on were tight . They should have a tight interference fit . I checked the dealer and they aren't available seperately and the whole shaft isn't either but you might want to double check on that . You might get a machine shop to make some for you , they should be easy to make and put on . Maybe tack the old ones back on with a welder on the outer end ? Sorry I couldn't be more help . Where are you located ? Good luck ...Randy
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|