Farmall & IHC Tractors Discussion Board |
Re: IH 656 Hydro / Ex Valve
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Roy R on June 14, 2006 at 10:46:19 from (129.79.110.28):
In Reply to: Re: IH 656 Hydro / Ex Valve posted by the tractor vet on June 13, 2006 at 15:59:05:
I started out using 15W45 oil and just changed it. Not sure what you mean when you say low ash? I was also using a lead additive and 89 octane. Do I need to quit with the additive and go to the higher octane? I have not checked the timming; however, I did find the fuel mixture way lean. I have bought the next range colder plug and will do a quick run and another comp. test (wet test) to see just how bad. Sort of hoping against hope that there was something under the valve, carbon maybe. Are you saying that it might be possible that the valve adjustment could be far enough out on just that one valve to cause it to have the 10-15lbs of compression? All of the things you have mentioned are cheap compared to the time and cost of another valve job, which may be where I am headed. Thanks for the help!!
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|