Farmall & IHC Tractors Discussion Board |
Re: TD24 vs CaseIH quad?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy-IA on December 14, 2005 at 18:50:44 from (209.152.95.42):
In Reply to: TD24 vs CaseIH quad? posted by R-cubed on December 14, 2005 at 15:01:19:
Hi , I don't know how a tractor would react but back in the late 70's and early 80's we had pull-off's with van's in the van club's that were around then . Same thing , chained two customized , wide rear wheeled van's together on asphalt and smoked tires sometimes till they exploded . It really was good fun - back before the safety police started trying to get rid of fun . Today , at four-wheel drive event's they chain big wheeled four-wheel drive custom truck's to a immovable object and call it a smoke-off till the tires explode in some cases . I've been four-wheeling for fun for about the past 30 year's and wouldn't even think of pulling another vehicle with a chain or a " tow rope " - the kind with a hook on them . " Tow ropes " or " tow straps " with hook's are designed for just that - towing a movable vehicle . Chain's on the other hand offer no " give " and as such are extremely hard on vehicles . Recovery straps or the slang name " snatchum " or " snatch " strap's are designed to stretch and " recoil " so to speak , multiplying the force imposed by the movable recovering vehicle . They don't have hook's , just loop's at the end's and are available up to 60,000 lbs ultimate load capacity . They will still break sometimes so laying a coat , piece of carpet or a heavy towel over the midpoint will dampen the free ends if it does . This applies to chain or cable as well . It isn't as effective but is better than nothing . I witnessed a 1-1/2 " Hyster winch cable break years ago trying to get a D-9 Cat unstuck from a slurry pit . It wasn't pretty . Nobody got hurt but it dented the back of the Cat under the winch about 4" deep . That was 1/4 " steel plate . About how big of chain - personally , I'd add together the weight of both tractor's and multiply by 2 . Two tractors at 5000lbs each X 2 = 20000lbs . Get a chain that'll handle that load . The graded chain I use on the semi's will handle 6600lbs for a 3/8" chain . So think about it . Go to a sled pull or ask a puller what size chain is on the sled . JMHO . Take care and have fun ! ....Randy
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|