Farmall & IHC Tractors Discussion Board |
Re: 504 utility steering arm
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TDK on September 25, 2005 at 11:45:19 from (205.188.117.73):
In Reply to: 504 utility steering arm posted by sam kissinger on September 24, 2005 at 16:23:12:
We have a 504 that was repaired before we got it. Someone drilled the shaft and arm. Then put a 3/8 or 7/16 grade 8 bolt through it. Another idea is to remove the arm and split it using a saw or die grinder and thin abrasive disk. Squeeze it together at the cut in a vice and weld together. This will take some, if not all, of the "slop" out of the arm. Or you could just do as you Cowman suggested and weld the arm to shaft. Don't worry about seals, as there are none in the spindle.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|