Farmall & IHC Tractors Discussion Board |
quick hitch on a farmall 200
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ben kudwa on August 28, 2005 at 03:58:25 from (207.179.77.74):
In Reply to: IHC 300 Utility fast-hitch posted by bent on November 25, 2004 at 06:44:07:
I am considering purchasing a conversion kit to be used with 3 point implements. What is the best type to purchase? Apparently Farmall made a conversion as I have seen them advertised on eBay. Is this the best type to use? Will the 200 support a 5 to 6 foot mower or brush hog? Will the pto turn the unit fast enough. I recently purchased a woods belly mower for a Farmall C and it works great. However it has a very large pully on the rear to provide the turning speed needed to properly run the mower.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|