Farmall & IHC Tractors Discussion Board |
Drawbar for a 140 hi-clear
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Swampcat on June 22, 2005 at 20:03:09 from (68.226.206.146):
I'm using a pull-type 5' shredder behind my 140 hi-clear. Its got the standard drawbar that I got from a junkyard. The hitch point is only about 4" behind the end of the pto shaft. When using the bush hog I'm afraid to make any more than the slightest turn because the gears in the 140's gearbox start to make a lot of noise and vibration increases a lot. Do I have the wrong drawbar? Can I make turns with less strain on the gearbox with a drawbar extension that puts the hitch point at least 14" behind the pto shaft? Something's not right about my hook-up. Thanks for any suggestions.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|