Farmall & IHC Tractors Discussion Board |
Re: International H. tractor model 444 stuck in 4t
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB2 on June 19, 2005 at 17:39:55 from (69.196.154.214):
In Reply to: Re: International H. tractor model 444 stuck in 4t posted by oldtymer on June 19, 2005 at 16:43:10:
Hi Oldtymer, I know the block your are talking about. It has a shut off valve and slow/fast valve. Never had this valve body off so don't know problems one could get into. It must have been a shorter bolt on the 434 as I remember only being able to turn it with open end wrench and there wasn't enough clearance to remove the bolt but slid the cover forward enough to pass the valve body. The problem with our 434 was, it would jump out of 2nd gear going down a hill. There was a detent on a fork shaft that was worn. I also remember it was a bit of a struggle to get everything lineup and back together. Good luck JB2
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|