Farmall & IHC Tractors Discussion Board |
48 cub won't fire
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by WOD on May 23, 2005 at 16:00:49 from (152.163.101.13):
Well, Here is where I am. I now have spark at the plugs. The plugs are old..so I'm going to replace them. It still won't start. I want you guys to double check my procedure here: 1) pulled the rotor button off. 2) pulled the plate off (has a little gear in it) off that covers the points. 3) cleaned them and noticed a mark on the little gear. Timing mark I guess. 4) well, there was no mark on the rotor button gear. But on the outside of the rotor button there is what looked like a mark to me. So I matched that up with the little gear mark and put it back together. At least now I have spark. My question is, Did I do the timing procedure correct? Thanks, WOD
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|