Farmall & IHC Tractors Discussion Board |
Re: CLUTCH REPLACEMENT
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on January 16, 2005 at 17:02:38 from (12.65.61.176):
In Reply to: CLUTCH REPLACEMENT posted by FRANK H. on January 15, 2005 at 10:45:11:
Yes, if you have the 11 inch clutch (normal for an M) you can do it without splitting. I did it about 5 years ago. However, it's a dirty job working under the tractor and it's a chinese puzzle. Took me a full day plus some consulting with a local mechanic to get the clutch out. Now that I know how, could do it in an hour or so (once the lift all unit is out). Instructions don't say, to remove the cross shaft that works the clutch throwout but I could not get the main drive shaft out until I took that out. There are bolt holes in the clutch plate to compress the springs. You take out three of the bolts that hold the clutch to the flywheel and put them in the holes to compress the clutch. After that take the main drive shaft coupling loose and everything else out (cross shaft, clutch fork, etc) and you can tilt the main drive shaft enough to get it out. Also, the clutch fork is keyed to the cross shaft with heavy washers on the clamp bolts of the clutch fork. Tight working up in there! If you have equipment to support tractor, may be easier to split it. But...many hobby type folks don't have the stuff to split a tractor safely.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|