Farmall & IHC Tractors Discussion Board |
Re: Super A touch control rebuild followup questi
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scott#2 on January 13, 2005 at 17:32:50 from (141.156.18.82):
In Reply to: Re: Super A touch control rebuild followup questi posted by scotty on January 13, 2005 at 09:27:07:
Thanks for all the help guys. I think I found out where those other 4 orings go. The 2 tan ones go under the late model high pressure pistons before bolting them to the rods. Not used on the early units as those shafts are tapered. The other 2 that are supplied as 1 each, I believe go into the optional remote hyd. control valve. I think that anyone who has completly redone an early block without the optional remote would have 8 rings left over. It makes sence since they give you every thing from the block to the pump. The optional hyd. valve is in between. Not going to mess with that at this time Thanks for all the comments, I am keeping all of them in mind as I go through this thing. scott#2
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|