Farmall & IHC Tractors Discussion Board |
Re: H manifold or Header
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on January 04, 2005 at 16:09:24 from (66.203.172.221):
In Reply to: H manifold or Header posted by danielgillespie on January 04, 2005 at 14:43:09:
Daniel, I am not questioning your ability to do this but you realize that the intake is part of the system. It would be a trick to fabricate a custom exhaust that also allows a flow of fuel through an integrated intake with your header. It would have to be very accurate to get even distribution of fuel to each cylinder. I bought an new manifold for my H for $190 Canadian, changed it in about 10 minutes and it was done. You could spend a lot of hours trying to perfect what you have in mind..but good luck if you go for it....Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|