Farmall & IHC Tractors Discussion Board |
Re: 50 M Carb
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ChadS on October 17, 2004 at 08:40:37 from (66.228.96.214):
In Reply to: 50 M Carb posted by Adam Whitson on October 16, 2004 at 17:44:56:
Let it soak for a few days, have you removed the bigger brass metering stem in the center of the bowl? if that is plugged up, the passages go though the casting straight to the metering stem, usually, the stem gets clogged up, and it spreads into the idle circuits. you should be able to hit it with the air from all the passages around the jet, where the metering stem is located, and air should come out both holes you described. if not keep soaking it, and blowing it out with air until it cleans out. Worst carb I have ever messed with was on off of a burned tractor, took me 2 weels to get it cleaned out, it runs great!! Hope this helps,, ChadS
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|