Farmall & IHC Tractors Discussion Board |
Re: Super C Oil Pressure...??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on September 13, 2004 at 18:59:48 from (64.12.117.22):
In Reply to: Super C Oil Pressure...?? posted by BobG in VA on September 13, 2004 at 18:05:01:
I had almost the same problem with my SC. Changing the oil gauge made a big improvement but pulling the oil pan and the bottom plate from the oil pump. After I had trued the bottom plate and put on a new gasket I had good full presure all the time. A good perfectlly flat surface is all you need with some fine grit emery paper you will be able to true the plate. The gasket is still available from CIH and it is the thinest one I have ever seen. GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|