Farmall Tractors Discussion Board |
IH 424 BRAKES
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Buck on October 25, 1999 at 18:10:01 from (209.240.200.44):
Purchased the IH 424 a few years back. Needed an exaust system and brakes. Neither was a problem and the person that I purchased it from said that it now had good brakes for an IH. Now that I have used it for awhile I keep thinking that it should not take so much pedal pressure to apply the brakes. I cleaned the plates that apply pressure to the disk and also cleaned the steel balls and springs between them and replaced the four disk pads. I did not lubricate/grease the ball area.Everything appeared fine and I do have brakes. Is there something I overlooked or is it normal for this tractor to require a lot of pedal pressure.
Follow Ups:
Post a Followup
|