Farmall & IHC Tractors Discussion Board |
49 M 3 bolt drum disk brake adjustment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jamie on April 23, 2004 at 22:59:25 from (24.178.78.229):
Since this isn't covered in the owner's or service manuals and this was an add-on, whats the process for adjusting these disk brakes (3 bolt drum)? externally, I only see the nuts on the bolt coming out of the drum and the linkage with the spring at the base of the pedal. I figure the linkage is to adjust free movement of the pedals and the bolt coming out of the drum is for adjusting the brakes, but I'm not sure of the sequence. From what I've tried, it seems that I have to do a lot of trial and error of adjusting the linkage and then having to back out the nut on the bolt coming from the drum to be able to get the pin back through the linkage and then tighten the nut back down on the drum. Seems like there has to be an easier and faster way.
Follow Ups:
Home
| Forums
Today's Featured Article -
A City Guy's First Tractor - by Fred Hambrecht. After living in apartments in Atlanta for more years than I care to remember, the wife and I decided to move to the country. Humming "Green Acres is the place for me..." we purchased a 29 acre tract about 60 miles south of Atlanta. Next came the house, I could talk about that ordeal for another two weeks... But, I want to talk about my tractor! We didn't even own a lawnmower, and all of a sudden we had enough grass to feed all the starving children of the bovine world. Naturally, I talked
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|