Farmall & IHC Tractors Discussion Board |
424 3PT Raises on startup and can't be lowered
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on December 22, 2003 at 13:38:41 from (209.226.181.179):
My hydraulic 3pt as soon as the engine starts the lift arms fully raise and stays there. It does not respond to the control lever for down, even though it's already in down position. I noticed that when I position the lever slowly to raise the arms and I get 3/4 way thru, the engine wants to stall. When I turn off the engine the 3pt goes back down again. Draft control is full forward as usual when not being used and so is the position control forward (down) on the quadrant. The fast/slow lever is on fast and the isolator valve is open as normal. Was working fine when I parked it and when I started it, it suddenly started to do this. Thanks for the help.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|