Farmall & IHC Tractors Discussion Board |
Re: Re: 2 row Deering/IH Planter
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Double R on May 25, 2003 at 06:38:34 from (204.39.225.61):
In Reply to: Re: 2 row Deering/IH Planter posted by Hugh MacKay on May 24, 2003 at 18:04:13:
I assume you are talking about the seed plates. I have a IH steel wheel two row planter. I have two 5gallon buckets full of seed plates. The other post is correct that you can still get plates and the new ones are plastic. Match the seed to fit into the plate properly, not too tight and not too lose. Take your plate out and place it on a flat surface to optain this goal. Also the plates come with different number of holes depending on how close or far apart you want your plants. I always do a pretest down the drive with the planter down. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|