Farmall & IHC Tractors Discussion Board |
Re: H Fan removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F20II on May 14, 2003 at 09:04:52 from (208.187.14.178):
In Reply to: H Fan removal posted by gmiller on May 14, 2003 at 07:53:54:
You must loosen the fan belt first, there is a set screw on the the pully, loosen theis screw an turn the out side part(closest to the fan) counter clockwise to loosen. Then there are 4 bolts on the front of fan blade, remove those, fan will come off along with pully. You may have to tap on it a bit, also lookout for your knuckles, it's a tight fit. You will then be able to see the water pump an the bolts to remove it. Case/IH dealers have the bearing an gaskets if you need them. If you look at my Epson site I have a 43 an 42 H apart with pictures of the pump an fan listed there, might make it easier if you look at that first :o), hope it helps you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|