Farmall & IHC Tractors Discussion Board |
Re: Re: 3 timing notches on crank pulley which one to use???????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chad on February 26, 2003 at 08:42:24 from (152.72.252.244):
In Reply to: Re: 3 timing notches on crank pulley which one to use??????? posted by BigRed on February 26, 2003 at 08:32:00:
I just rebuilt a 1948 H with my dad and when I got it running in september I did something wrong and I have it running 180 off. Number one plug wire is on number 3 and number 1 is on number 3. I just left it since it runs good. I just didn't want to pull the distributor again. This time I want to do it right. I think I used the single notch last time or something. I want to get this one right while it is easier to work on it. do you remember what the valves need to set at cold? .017"?
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|