Farmall & IHC Tractors Discussion Board |
Re: Thrust Brg. on Govenor ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on January 07, 2003 at 20:25:47 from (151.202.82.173):
In Reply to: Thrust Brg. on Govenor ? posted by I RIGHT I on January 07, 2003 at 16:46:34:
Ooops! The bad news may be that you are looking for the races and about a dozen little balls :^( The inside diameter of the bearing is such that it fits right over the shaft--outside is 1/8-3/16 wider all the way around. Unfortunately, it is two cupped rings and the balls and nothing holding them together but the pressure of the thrust spring. If you can't piece it back together, CaseIH still stocks them. I think I lost about four of the balls just opening up the governor the first time and had to buy a new one.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|