Farmall & IHC Tractors Discussion Board |
Re: International 650D Questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rider on December 12, 2002 at 20:06:07 from (65.239.11.202):
In Reply to: International 650D Questions posted by Ron in NE on December 12, 2002 at 18:41:26:
I also have a 600D International. Besides those differences mentioned the 600 and 650 had live hydraulics with up to two hyratouch valves. They also had a instrument pod that mounted to the steering wheel shaft housing that included the normal gauges plus a tachometer/hour meter. There is also a cowl just behind the fuel tank that attached to both fenders. This cowl was made to enclose the hydraulic lines for the hydraulic system. The heads for the 335 and 350 are the same the difference is in the fuel delivery system, the injectors and the pump. Actually in 1956 you could have purchased a Super WD9 a 600 or A 650 and they could all be a 1956 model.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|