Farmall & IHC Tractors Discussion Board |
Re: Needed:.....Countershaft Seal Info for a Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on October 30, 2002 at 19:34:42 from (207.178.96.214):
In Reply to: Needed:.....Countershaft Seal Info for a Farmall M posted by Night Stalker on October 30, 2002 at 02:28:36:
Number I have does not agree with Jim's. This is for an M not a Super, have no idea if they are the same since I have never had one apart. If I have misidentified the part, I apologize to both of you. According to my book, item #70 is a seal for the control shaft that attaches to the arm and rod that you pull to operate the lift all. It lists two numbers: 19812D for shaft #15089E, and 494027 R1 for shaft #15089EA. However the only shaft listed is the advanced number 15089EA. I think I would take the seal to NAPA with both part numbers and see if they have one to match.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|