Farmall & IHC Tractors Discussion Board |
Farmall F20 help needed
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kenny on May 28, 2002 at 07:36:14 from (170.76.19.10):
I have restored several F-20's. I just got a 39' that has lights. There is one mounted on on a cultivator bracket on the front right, 2 on a light bar (simular to an H or M, but the bar is different)The light bar has a small IH amp guage. There is also one light on the back right. These look like the lights on an H or M. Did the F-20's have these type lights. The ones I have seen in Pics have to large lights mounted on each side. Also this F-20 has a hydrolic pump on it (IH pump). when did IH start putting Hydrolic pumps on? The pump runs off the PTO shaft between the clutch and rear end gears. There is a bracket that was used to attach the pump. The bracket goes around the main shaft and around the PTO, Just under the main shaft. The shaft has a gear of tooth(like the belt pulley attaches to, but smaller) How do I remove it to take the bracket off? to mount the pump on another tractor?
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|