Farmall & IHC Tractors Discussion Board |
Farmall C Magneto Timing Problem
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Paul f on May 17, 2007 at 13:01:36 from (63.163.109.121):
I am trying to time my neighbors C that has an H-4 Magneto. I cannot get it to trip at TDC. Even with the magneto rotated as far as possible away from the block the impulse trip occurs when the mark on the flywheel is almost 1.5 inches past the mark on the housing...Rotating the mag back towards the block moves the flywheel mark almost out of site (to the right as you are looking forward). The slots on the drive flange are parallel to the ground at TDC so I do not think the drive gears is out of alignment. I looked through some of the archives but am still unsure of what the problem might be. Sorry to say I am a Case guy (DC & VAC both with distributors) so please be patient with me... Thank you I have looked through the archiv es but didn't see
Replies:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|