Farmall & IHC Tractors Discussion Board |
Re: Re: super (m) rpm
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bud barenie on September 04, 2001 at 06:47:45 from (206.25.96.46):
In Reply to: Re: super (m) rpm posted by Dale13 on September 04, 2001 at 05:17:55:
dale: thank's for the reply ! pulling transfer sled. rpm's can't be over 10%, from stock super m factory spec number . i think the book calles for 1760rpm's have any input on tire pressure ? i/m running 15.5-38 firestone 45degree on 14" rims pullin two classes 5500.-6500. and 6500. to 7500.0 pulled this past sunday 1st place in 5500.-6500. weighted 5580.0 . in the heavy class weighed 6750.0 tires held well but engine ran out of gutts should have dropped weight on second chance. ended up in 7th place !!!! i/m going to pull off the draw bar next pull, but it has to be attached to the hitch. i'm going to make a bracket to allow it to float on the hitch. pulling front end of the ground in both classes !! 96.0lbs on the front in heavy class !!!
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|