Farmall & IHC Tractors Discussion Board |
Re: farmall H trans fluid changeout
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on June 16, 2001 at 09:42:55 from (12.75.196.15):
In Reply to: farmall H trans fluid changeout posted by Bradley on June 16, 2001 at 09:31:32:
Bradley you definitely want to remove that front plug also. You will get a quart or 2 of 90 weight from there. Also on the belt pulley. The transmission slings 90 weight into the belt pulley assembly. It is designed to hold about 1/2 quart in the lower section of the assembly. Remove the 4 face bolts and tap the pulley out about 1/4 inch. The face casting will also come out with the pulley. You will get a good 1/2 quart or so of 90 weight and water. Condensation collects in the belt pulley assembly being the highest point on the transmission. Save 1/2 quart to a quart of the new 90W to refill the belt pulley assembly. Filler plug is on top. Don't worry about overfilling. The excess will drain back into the transmission.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|