Crawlers, Dozers, Loaders & Backhoes Discussion Board |
Re: Freezing hydraulic valve?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob/Ont on February 25, 2007 at 19:15:39 from (172.132.209.247):
In Reply to: Re: Freezing hydraulic valve? posted by 135 Fan on February 25, 2007 at 09:08:10:
Sounds to me like the valve body is warped. If all spools are in a bunch of sections held together with long studs try slacking off the nuts a turn and see what happens. Then pull out that spool and see if it has any big marks on it that could be polished off. Another thing make sure the quick couplers are in good shape, not worn in the groove where balls lock it together or the entire system might not work. If coupler not together tight the oil will not go through. Later Bob
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|