Posted by AJ. on July 28, 2013 at 18:34:46 from (184.108.40.206):
In Reply to: 977H 53A track posted by rebible on July 28, 2013 at 12:55:27:
Have another go at posting the picture/s,when the roller flanges hit the pin bosses it is because the rails and rollers are worn,measure the hight of the rail and the diameter of the roller where it runs on the rail and that will give you a pointer,the rail hight if I recall correctly is about 4.6",can't remember the roller diameter,someone will know.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.