Posted by lyle niemi on November 26, 2012 at 04:23:57 from (220.127.116.11):
In Reply to: Bucket Teeth posted by JIMO on November 25, 2012 at 15:12:12:
what I would do is cut the old shanks off and weld on some new ones. You only need about 4 or 5 on that bucket. On one of my backhoe buckets had bought shanks that fit a bigger trackhoe and welded them on my backhoe bucket, they have the pin and washer system to hold the teeth on and makes it alot easier to change teeth
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.