Case Tractors Discussion Board |
Re: VAI / VAC Draw Bar Bolts In Rearend
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mj on June 28, 2006 at 10:01:24 from (69.85.83.212):
In Reply to: Re: VAI / VAC Draw Bar Bolts In Rearend posted by '53 VAI Guy on June 28, 2006 at 04:53:13:
That is a 5' K.Kutter shown in the photo. I'm using an over-running clutch on the PTO which adds some length and would probably create too extreme an angle for the mowers' u-joints but I had already added 3" to the lift arms on the tractor for better compatibility with non-CASE implements so it works well. I also shortened the mowers' driveshaft 4" since the driveshaft could not be removed without unhoooking the mower first. You might want to look at my webpage for more VA Series info and photos.
Replies:
Home
| Forums
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|