Case Tractors Discussion Board |
Re: '44' Case VAC
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wheat straw on July 03, 2003 at 15:12:09 from (166.102.155.62):
In Reply to: '44' Case VAC posted by Arthur on July 03, 2003 at 06:56:28:
Arthur, Does it have a lever on each side of the seat with a hitch point on each side the draw bar. One lever will raise one side up and down while the other will raise both sides up and down. If so you probably have the vcmb plow mounting. One of these levers was the "draft controll" while the other was a level adjustment for the plow. Wish you were closer. I'd be interested in the mount if it is complete. Someone made copies of a manuel for one of these plows which shows you this. Look up vcmb manuel in this forum and see if it comes up. Dad had one for years but finding it would be like a needle in a ........ well, you knpw. Have fun. Wheat Straw
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|