Posted by Christopher Mikesell on April 29, 2014 at 21:25:54 from (107.134.164.80):
In Reply to: DC 4 posted by MT RON on April 29, 2014 at 19:58:24:
No, the eagle hitch DC tractors do not have any type of draft control. They have position control only. The geometry of the eagle hitch and the mast of the plow work together to allow the plow to hold an almost constant depth. You must adjust the plow to match the tractor just like with a trailer plow. However, a DC is a 3-plow tractor and should have no problem pulling a 14" or 16" 2-bottom ford plow, if the tractor is running right. Also, the eagle hitch setup works best if you use the original upper mounting point on the tractor, and the original length top link. To make this work, you will have to alter the mast on the ford plow so that the plow sits level in the furrow with the top link in the middle of its range of adjustment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.