Posted by Mike barcia on September 18, 2013 at 17:08:02 from (74.102.111.143):
In Reply to: Case 1194 drawbar posted by Mike barcia on September 17, 2013 at 05:44:27:
So I found at least two sources for the original drawbar but I think I am leaning towards a three point one.
Either way by looking at the original drawbars, I see that there are 5 holes total. There is one for the implement hookup at one end, and two smaller holes near the implement hole to add on the clevis bracket. At the other end, there is the hole for the pin under the tractor, but then there is a 5th hole similar in size to the tractor pin hole diameter but it is more towards the center of the drawbar. I think it is just for drawbar length adjustment, mainly for using pull type pto implements, but i am not positive.....so What is this 5th mystery hole for?? I'm just wondering and thanks for all the info!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
