Posted by Stumpy(NH) on July 06, 2013 at 18:07:24 from (22.214.171.124):
I got a call to help a fella bale his hay. His baler broke. I took my trusty 230 over. I baled about a hundred twenty, then it missed while changing twine balls. No biggie, re threaded the needle and tripped the knotter........It"s all bad from here. Something happened. The knotter chain drive broke. It had been repaired before. I repaired it again. Made sure it was set back, turned it through a tying cycle. Everything looked OK. I hopped on the tractor, engaged the pto and started the next bale. Then it happened. Bang goes the needle as it breaks.
So, my question is, how hard is it going to be to find a needle or set of needles for my baler. Please don"t say junk it, I really like this baler!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.