Posted by Joe Young on January 21, 2013 at 04:28:50 from (64.126.67.179):
In Reply to: 630 posted by caseanonymous on January 20, 2013 at 13:30:11:
Case used two different carburetors during the 630 production run.
Zenith - 0-12534
Marvel Schebler - TSX-799
In my opinion, the easiest and best route if your wallet will stand it is to buy a new Zenith replacement. I believe the current number 14996 is the correct replacement. It can be had for around $250.
I've attempted to rebuild several old carburetors, and sent several out for rebuild. In nearly all cases, they simply don't work well for me. As an example, I rebuilt a MS TSX-635, then replaced it with two other "professionally" re-built units. In all cases the tractor ran terribly. There was no way to get it set properly. Finally I installed a new replacement Zenith and the tractor starts and runs like a top. My experience has been similar on several other 40-60 year old tractors. Many of these old cores have been re-built numerous times and are junk.
Your milage may vary.....
This post was edited by Joe Young at 04:38:04 01/21/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.