Posted by Brokengun on November 25, 2012 at 20:10:04 from (4.252.31.231):
I have a 930 Gas CK that was converted to LP using a century conversion kit.
When the conversion was done the exhaust manifold was broken and a piece welded over the area that connects to the gas intake manifold to the exhaust manifold so that the 2 DO NOT connect.
The exhaust manifolds has now gone bad and I was going to replace it with a new exhaust manifold from a diesel that I all ready have.
I know the mounting holes are different between a gas and diesel manifold and I know the diesel has a different pattern for the manifold hold down studs.
I was planning on drilling new holes in the Diesel manifold and making the slight alterations to make the diesel manifold work.
What I didn’t realize is the diesel manifold gaskets were different than the gas.
It seems the diesel manifold set has a larger opening for the air intake than what is on a gas tractor.
So where can I get a set of gas manifold gaskets for a 930 CK.
I also need to know if anyone has tried converting a 401 Diesel exhaust manifold to work on a 377 gas and what kind of problems you have encountered.
My fear is I wont have the necessary clearance between the diesel exhaust manifold and the old gas intake manifold.
(It appears the gas exhaust manifold is smaller than the diesel exhaust manifold)
I don’t want to spend the $80-90 for a set of case manifold gaskets for a 377 gas to only find out the diesel manifold wont work
I can not find an after market set of manifold gaskets for 377 gas.
Will I be forced to pay Case prices for a set of manifold gaskets to make this work, if it can be made to work??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.