Posted by Dave1370 on November 12, 2012 at 16:16:27 from (184.108.40.206):
Ok, here we go again. After I replaced the C-1 clutches, master seal kit, new pistons, and the "large" snap ring that goes inside of the drum, I slid her back together. Filled it up with new oil and went to start it up for the first time when the new problem was discovered. When I split her, she was in neutral, however, now its stuck in 4th. I jumped the neutral safety switch and turned it over several times. Still unable to get it out of 4th tho. Any suggestions? I REALLY don"t want to split her again
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.