Posted by glennster on October 01, 2012 at 13:12:46 from (184.108.40.206):
helping a neighbor resurect his dads 400 case gasser. sat in the barn for 20 some years. changed all the fluids, a little work here and there, and finally got it running. i believe it is a 410 model as it is a narrow front gas tractor has an eagle hitch and one set of rear remotes. the hydraulic control levers are stuck in the neutral center position. dropped the linkages off and the levers move freely. removed the inspection cover on the rear end above the pto, and the linkage has about 1/4 inch movement either way. no rust in there, pretty clean considering. feels almost like there is some type of stop bolt or safety stop blocking movement. neither hitch control or remove lever will operate. any ideas?? he does have a 2nd 400, identical to this tractor, not running either, and those controls are stuck too.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.