Okay, I understand that IT manuals are not always correct and different year tractors had different valve internals. I did not find a ball and retainer in either valve. I did find an orifice plate in bypass valve and perhaps the remnants of a screen.
When removing the bypass valve, I thought I felt it break free when inserting the wooden stick. I used penetrating oil and it did not take long to get both valves out. Both valve cartridges have shiny wear spots and a few pits. Was planning to smooth the bores and cartridges by wet sanding. When done should I reassemble and try it? Or should i go to the dealer and see if I can get mesh filter, ball and retainer, etc.?
This post was edited by mooboy at 17:51:56 12/05/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.