Allis Chalmers Discussion Board |
Re: kub klipper mower
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Chuck Bergstrom on July 14, 2007 at 16:38:15 from (12.73.129.120):
In Reply to: kub klipper mower posted by l gehring on July 14, 2007 at 13:04:09:
I have a small booklet on the Kub Klipper made by Sunmaster. 2 belts are required, One is a double V and the other either round or V. The V was an optional belt. It shows only one part no. blade so I think they all turn the same direction. The double V belt goes around the outside of all 3 blade pulley's and the opposite side of the belt goes around the lower groove of the drive sheave that is horizontal. The round or V belt goes on the pulley on the PTO shaft-then down behind and around the 2 idlers and to the top groove of the the double horizontal sheave.
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|