Posted by soundguy on May 09, 2014 at 16:50:31 from (207.30.46.70):
In Reply to: charging issues posted by d17man on May 09, 2014 at 14:48:52:
start with a motor test of the genny, thenmove to a full field test.
and to dothat.. you need to determine if A circuit or B circuit.
look at the bottom of the reg. if there is 1 bias resistor and it is between the field tab and the ground tab/case.. it is likely A circuit.
if there are 1 or 2 or more bias resistros... and one is from field to armature.. it is likely B circuit.
to motor test A ckt, slip belt off.. remove feild wire.. jump field on genny to ground, jump bat hot to armature. if she takes off spinning.. genny is PROBABLY ok..
to motor a B circuit, slip belt off, remove field wire. jump bat hot to field AND armature.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.