Posted by maxwell99 on February 02, 2014 at 14:36:53 from (199.255.64.153):
In Reply to: 1963 d-17 series3 posted by JAL1012 on February 02, 2014 at 13:43:16:
I think you are ok. now that you have the bolt off take the nut off the bolt. clean the head area and the manifold surface good.
someone else will chime in here with more and better info,
but, I think you should put some type sealer on bolt, then buy all new nuts for you manifold bolts. some may recommend buying all new bolts I just did this to my little ferguson last year and I can not remember, I know I got all new nuts, but bolts I do not remember.
note to file: the threads Stretch, no kidding, so that is why you need new connectors. I would use two nuts locked together as you tighten the bolt back into the head. as you have cleaned the threads, you should have no problems getting the double nuts loose and off.
some tractors use thick flat washers against the manifold then the nut, some may use a flat washer, lock washer then the nut,
but the main thing is to torque the manifold nuts down to the correct pounds per sq in. you will need a good quality torque wrench. use a varied mixed pattern as you tighten the bolts. these items may be elementary to you, if so please disrequard, but serious mistakes can be made tightening bolts attached to the head, it's not like tightening bolts on an old plow or disc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.