Posted by JimIA on January 09, 2014 at 09:33:12 from (22.214.171.124):
In Reply to: Re: Roto baler posted by Aaron SEIA on January 09, 2014 at 05:53:04:
If baled correctly they do make a tight bale. Feed is a lot nicer as it isn"t beat up like a square bale. Straw is excellent and can be just unrolled. They are a different machine to run and it takes some getting used to. Like said before they can be labor intensive, but there are bale loaders out that that work too. Square bales have the feeding advantage if your just "throwing three flakes in the feeder". But I do think cattle waste less because they cannot pull flakes out of the feeder. I would go to a show and see one run and handle a few bales first and see if it suits your fancy.
If binder twine is not available in your area, one can use 16000ft baler twine. A different twine box construction is needed then, I have seen 5 gallon pails work.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.