Posted by 76redfred on November 11, 2013 at 16:51:49 from (64.246.125.54):
Hello I am working on a allis chalmers wc, and I am to the point where I am trying to start the tractor. I believe I have the mag timed right on the engine. I went thru the steps i found with TDC and then rotate back to the fire mark. I put a new zenith carb on it and have good gas going to the carb. I crank the tractor over and it will try to start and then keep cranking, then gas will seep out of the bottom of the carb. And then every one in a while it will backfire maybe once and sound like a gun going off. But then try to fire. Des anyone have any specific suggestions I can do to try and get the tractor going, thanks for any help!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.